leather studding

Replies to This Discussion

Permalink Reply by Brody Scumdog on September 21, 2011 at 12:03am

Leather Punch. I highly reccomend one.

 

• ▶ Reply

Permalink Reply by Steve on September 21, 2011 at 12:09am

I own one of these, blades on it werent sharp (nor were the replacement blades I got with it), but I work with metal allot and managed to get em razor sharp. Worked like a charm after that.

I'm just going to assume you (or anyone reading this wondering the same thing) don't have the means to sharpen the blades, so heres a method everyone can use:

1. Get studs, metal darts, backing materials (cardboard boxes, magazines, anything flat that can have holes poked in it) and a hammer.
2. Put leather on backing material. The backing material is there for the dart to sink into so you get a clean hole all the way through. That sounded dirty. 
3. Press a stud in the desired area, just enough to leave a dent where you want the stud.
4. Put the dart on one of the dents and hit it with a hammer until it goes through.
5. Do same to the other dent
6. Put stud in 
7. You probably know what to do from here

Don't hold the jacket and try to push the dart through. This will stretch out the leather, and it isnt very accurate.

• ▶ Reply

Permalink Reply by Sonny on September 21, 2011 at 2:12am

i use a small screwdriver insted of a dart

• ▶ Reply

Permalink Reply by Emmmallee on December 13, 2011 at 2:05am

Yeah but dont do what he did and hammer holes in the floor of the living room.

• ▶ Reply

Permalink Reply by Sonny on December 13, 2011 at 3:00am

as soon as i noticed i put something under it nd stopped the problem...

• ▶ Reply

Permalink Reply by Joey Simes on October 4, 2011 at 12:49am

I use an exacto knife to put small sluts in my jacket and a small pair of needle nose pliers to bend the prongs. 

• ▶ Reply

Permalink Reply by 28fa505fn33oe on November 17, 2011 at 10:18pm

sluts lol 

• ▶ Reply

Permalink Reply by chris (scum) gibson on October 4, 2011 at 7:31am

use a fuckin knife lol

• ▶ Reply

Permalink Reply by Andrea on October 4, 2011 at 11:13am

A serrated steak knife works just fine and a spoon is great to use to fold the stud prongs down! Seriously! Try it! Chances are you dont have the money or know where to get said leather tools,so DIY maaaang!

• ▶ Reply

Permalink Reply by Somber on October 22, 2011 at 9:05pm

I use a dart and a dime to bend the prongs. easy!

• ▶ Reply

Permalink Reply by Alex Underwood on January 9, 2012 at 11:04pm

mmy jacket has a little over 900 studs in it. i used a flathead screwdriver and an 8 pound weight and looooots of weed lol. weed for the patience

• ▶ Reply