mohawk methods

ok i was wondering how u guys spike your mohawk because i feel like im doing it wrong or something i just run gel through it then i hairspray the roots and it seems like it doesnt turn out right any suggestions?

▶ Reply to This

Replies to This Discussion

Permalink Reply by Steve on August 14, 2011 at 1:58pm

How I do it:

1] Using a comb to hold hair up, spray Rave (theres a spray called Rave, just to make sure something doesn't get lost in translation here) on one side (lets say the right).
2] Move onto next section with comb, spray on same side as in [1] (the right)
make sure to put the sections where the hair wants to be, not where you want it to be. By this point there should be a gap about 3 inches wide between sections [1] and [2]
3] Since you sprayed the Rave on the same side in the first 2 steps, graze your hair with the comb and the non sprayed side (don't stab it through, that'll just make lots of little gaps) into the gap from both sides, and spray (on the left, this time).
Repeat down head.
4] When you get your hair how you like it, (still use a comb to hold your hair in place so the dryer doesnt blow it around) go over it with got2b freeze spray.
The reason this works is because Rave is more watered-down then got2b, so when you spray it, it's only good enough to coat one side, leaving the other soft enough for a comb. It also adds thickness (why, I can't explain) so the hair at the top of your hawk isn't transparent.